These Roller Bunk Brackets are die-formed from heavy-gauge steel plate for long life. Four brackets required for installation of each pair of roller bunks. Made in USA. Per each. Available: Galvanized.
Roller Bunk Bracket, ordered 6 of theses they are well made and work great. They require 2 bolts which is good because they remain in a upright position. Like them well enough to order 6 more for another trailer. I do not find fault in not having bolts, washers and nuts as some mounts require long bolts and others short bolts. Good product made as advertised. Would recommend them.
These brackets did not line up to the holes on my trailer. The existing brackets had only one verticle slot for the bolts to fit in to bolt to the trailer. The roller bunk brackets have 2 verticle slots to fit bolts into to bolt to the trailer and they were spaced differently then the holes on my trailer. i had to drill the swivel part of the bracket off and use that piece with my existing brackets. So, the moral of the story is, that if you are going to use these brackets, make sure that they will fit the holes on your trailer.
I had to remove the top parts of the brackets by drilling out the pin and putting them on my old brackets,just to lower my roller beds to touch my center rollers.They don't pivot anymore but my boat sits nicely on the beds and centered great.I had an EasyHaul trailer,but if I would have had a different one I might not of had to adapt these brackets.I keep the other parts in case I change trailers later.All in all good brackets I didn't have to send them back and they did do the job..
There were no bolts or other attaching devices with the brackets. I did not use them and now have them setting in my garage collecting dust. I have no way to return them that I know of. Appear to be a useful product but you better know exactly what you are getting before you order. Make sure there is an adequate picture of the product.